
( Brand: Skf ), ( Manufacturer Part Number: 99251 ), ( Part Type: Engine Crankshaft Sleeve ), ( Country/region Of Manufacture: United States )
Then place the installation tool over sleeve. Clean away sealant that migrates to the shaft or sleeve outside diameter surface. The arithmetical mean of these measurements determines the size SKF Speedi-Sleeve. Install the sleeve before filler hardens, allowing to wipe off any excess.
The flange will break loose along the tear-off groove. The diameter of an undamaged section the seal counter face should then be measured on at least three different planes. Measure to the exact point, or mark directly on surface. If the installation tool is too short, a length of pipe or tubing with squared-off, burr-free end can be used.
No expensive machining or preparation is required before mounting. Its quicker than revitalizing or regrinding, and provides an improved sealing system. After positioning the sleeve, use standard pliers to bend flange back and forth around its circumference along shaft axis. And each SPEEDI-SLEEVE comes as a kit with disposable installation tool.
Product ID: 10248073. Material: Stainless steel. The outside surface of an SKF SPEEDI-SLEEVE forms ideal sealing. Optionally, a light layer of non-hardening sealant.
Manufacturer part number: 504102. SAME DAY SHIPPING - ORDERS BY 4 PM, : : Product characteristics. Can be applied to the inside diameter surface of sleeve. Delivery Information.
The same size seal as the one being replaced fits snugly onto new surface. Low in cost, a SPEEDI-SLEEVE is slipped over the worn area quickly and easily, provides surface that actually harder than of new shaft. Inner dimension: 63,910mm. These thin-walled stainless steel shaft repair sleeves can come to immediate rescue when a crankshaft needs new sealing surface.
Cut only into the tear-off groove, not onto finished sleeve surface. SPEEDI-SLEEVE: The SKF SPEEDI-SLEEVE is a fast and effective way to refinish worn shaft. While installation is simple, it must be done with care in order to assure proper results. Downtime is reduced since installation only takes a few minutes SKF SPEEDI-SLEEVE.
Be sure that the inside diameter of pipe is same as installation tool. Measure in three positions and average the readings to make sure shaft is within recommended specifications. If the flange is to be removed cut perpendicular tear-off groove with a metal shear. Country of origin: USA.